Fostex DMT-8VL - Page 139

DMTSVL Owner’s Manual (MMC/FEX Ust/Mainrenamv/SpedHeations)
Status Request
— _
Status request command Status reply
Cwrirth'iW to PfifVOSTT 3 ver 2-Q/Dtrr-Svi i P BQ/DMT 8 ver ZCVUMT-Bn to controller
1 Loop op. status 22 21 32 21 (<Loop op. mode - 12>)
loop sttfus 22 22 32 22 (<on/off>)
Post locate status 22 28 32 28 f<pasf Joe* re sta\us>)
Auto rec slat u* 22 2D 32 2D (<edit message>/
Lock statu* 22 41
32 41 (dock status>)
Copy dip status 22 45
32 45 (cedtt messaged) 1 or-I4>)
Copy paste status 22 46
32 46 (<edtt me*sage-02> <mmc time>)
or
32 46 (<edit mcis*ge-OQ>)
Erase status 22 47
32 47 tcedit mcssagc-02'-<mmc Ume>)
or
32 47 (edrt metsage-00>)
Sondes, mode 22 4C
32 4C(<on/ofT>>
Move dip status 22 41)
& 4D (<edtt message-01 or - 14>)
Move paste status 22 4E
32 4E (<edit message-G2><mmt Ume>)
or
32 4E(<edit mess*ge-00>)
Digital In ch. u 23 41
33 41 (<channdxchannel>)
Digital out ch. $t. 23 42
33 42 (<channei><cbannel>)
Program status 23 43
33 43 (<treogram>)
1 Click status 23 44
33 44 (<on/ofT>)
[ Level status 23 45
33 45 (<count»08><Jevel data>)
<Note 1>
Sondes, mode:
Abbre\iation for *i non destructive recording mode ". When this mode is ON, not
only ''takes* nude by various sound editing or AUTO PUNCH IN/OlfT but "takes"
recorded by simultaneous pressing of the PLAY and RECORD buttons (direct
recording) will always be possible to UNDO (However, free disc memoryr space
equivalent to the recording length will always be required). This is the same
function of switching between "undoiALL (Nondes.mode:on) —— Edit (Sondes,
modeioff)* In the setup menu on the main unit.
<Note 2>
There is a limitation on specifying the <channel><channel> setting. For details,
refer to "Explanation on Command/\fodc Set" mentioned in later pages.
EXPLANATION ON READ/WRITE INTO THE VARIOUS EDIT POINT MEMORY
The MMC response/lnformation field "GP0-GP6" are allotted In the edit point
memories (clipboard in, clipboard out , auto punch In. auto punch out memory\ etc.)
which is necessary at editing. Therefore, at registering and readout of the edit point
memory, the "WRITE (40)" command and the "READ (42)* command of MMC must he
used. Relationship between the Edit point memory of D-80/DMT-S vcr2.0/DMT-8vi
and GP0'-GP6 are shown below 7
<Response/lnformation Field>
OS GPO : locate memory
OA GP2 : clipboard out memory
OC GP4 • ju/o punch in memory
OE GP6 : end memory
09 GPI . clipboard in memory
OB GP3 : start memory
OD GP5: auto punch out memory
OF GP7: reserved
139