Fostex DMT-8VL - Page 24

DMT-8VL Owner's Manual (Names and Functions)
Pressing this key while holding down the EXECUTE/YES key will switch the Time
Base (*) as follows. The Time Base can be set when the display shows the recorder's
current position or the available disk space (REMAIN).
- / ABS TH») j -)f B ARIJ CLk) - fUTC (MIDI Tw Coda))
(•) Time Bate:
The DMT-8VI uses time display <ABS or MTC) or Rar/Beat/Clock display to indicate
the current position of the recorder section. These displays are called ’Time Base."
ABS (Absolute Time) shows the absolute lime of the disk, and MTC (MIDI Timecodc)
shows the relative time obtained by adding an MTC offset value to the ABS value.
Bar/Beat/Clock (BAR/y /CLK) indicates a position within a piece of music and
conforms to the MIDI dock and Song Position Pointers created on the internal Tempo
Map.
• Rater to page* *114*. "125* and *127* tor more mtormaton about MTC and the irttmal
Map
[ * Rator to page "38* tor more ciormatton about Tima Ban_
43. Ex*cut«/Y«s key [EXECUTE/YES]
Press this key to execute the operation when you try to edit data on the hard disk
using the edit functions such as Paste and Erase, when you put the DMT-8vi Into
SETUP mode, or when you set the parameters in the SETUP menu.
Pressing the DISP SEL key while holding down the EXECUTE/YES key allows you to
select the Time Base. (Refer to the explanation about the DISP SEL key.)
* -. -. »
• Radar to poga *W toe mora Intanroflon a taJ uatog thtt k*y tor tha Pasta or F«R*a operation
• Radar to paga *103* tor mora Utonnafton about using tm$ key in SETUP moda
44. Exit k«y/No key (EXIT/NO)
Contrary to the EXECUTE/YES key. this key is used to stop the operation.
24