Fostex DMT-8VL - Page 23

DMT-Svl Owner's Manual (Names and Functions)
40. Clipboard In key [CUPBOARD IN]
When audio data is copied or moved, the start point of the copied part is stored in
memory. Pressing this key following the RECALL key (or pressing only this key) will
shew the stored data on the display and the recording section will enter edit mode.
In edit mode, use the HOLD/> key or shuttle dial to move around the digits* and use
the log dial to Increase/decrease the value.
If you press this key following the STORE key after the edit operation, the edited
value will be stored Into the key memory.
The data stored by this key can be used to locate data.
This memory Is reset to the factory default value when the power Is turned off.
41. Auto Play/Auto Return key [AUTO PLAY/AUTO RTN]
Pressing this key repeatedly will change Auto Play mode. Auto Return mode,
and Repeat mode On/Off as follows: (O: LED off, •: LED light up)
Auto Play mode;
In this mode, playback will start automatically after the START point is located.
This function Is effective at any locate points other than the ABS END point.
Auto Return mode:
When the END point is reached during playback, the START point is automatically
located in this mode. This function is effective only when the START and END
points have been specified.
^ —
<r 401 B>
Auto Rntum function is elective cr#y durtnfl pleyteefc In recording mode, ttie START pewit wi\
not tM located automatcaly atier the EfO port ■ « reached
Auto Repeat mode:
This mode is a combination of Auto Play and Auto Return, and plays back the pan
between the START and END points repeatedly. The auto repeat function Is effective
only when the START and END points have been specified correctly.
• Retar to pap *8 T tor datsls
42. Display Select key [D1SP SEL]
This key is used to change the display mode. Pressing this key repeatedly will
change the display mode as follows:
■ ^The currant poaftonJ j D«p4ay at no ovaiabto
me recorder senior
■ i **** ™ (REMAIN) ) -
23