FP Mailing Solutions optimail 30 - Sealer Moistening and Sealing Errors

optimail 30 Operator Manual
100
…when topping up water for envelope flap moistening/sealing
(optimail 30 with sealer)
Envelopes are not
properly sealed
Stroke your hand firmly over the envelope’s/letter
stack’s flap area.
Envelope flaps are not
moistened properly
Felts are soiled/dried out.
Clean sealer
(see Chapter 14.3.1, page 88) .
Top up water
(see Chapter 14.3.2, page 89) .
Moistening felt is worn.
Replace rocker with moistening felt
(see Chapter 14.3.3,
page 90)
.
Absorption felt is worn.
Replace absorption felt
(see Chapter 14.3.3, page 90) .
Moistening felt incorrectly seated in the rocker.
Correct moistening felt position
(see page 101) .
Absorption felt incorrectly seated in the sealer.
Surface is curved.
Check and if necessary correct absorption felt position
in the sealer
(see page 92) .
Problem Possible cause and remedy