Franke Kaffeemaschinen AG
TD-100356.doc 11 / 32
Initiate the command “Statistics from card (data)”.
The Flair data is read into Franke Service Animation.
Terminal download
Terminal 3000 has a Flash EPROM that can be updated with Franke Animation software.
The terminal software is available in two versions.
German / English
German / French
Follow the software instructions during installation. It takes about 10 minutes.
Update factory settings
The latest factory settings are written to the Flair.
After a successful update, you receive a status report that you can print out or save as a file on
your computer.
To Next Page
Loading...
