104
Start via key combination on welding torch
* Press intermediate lowering key to interrupt the pro-
cess
Press and hold the "LED" key
Press and hold the Up (+) key for 2 se-
conds
The filling process is started. It takes roughly 30 seconds to fill the torch hosepack. During
this time the LED on the welding torch will flash roughly every second
When the filling process has been completed successfully, a confirmation to this effect is
displayed.
IMPORTANT! Before starting to weld again, check the operating mode of the cooling unit
and, if necessary, apply the correct value for the task at hand.
1
2 s
*
2
1
2
To Next Page
Loading...
Need help?
General
