111
EN
System
Power source
configurations
Defaults / System / Power source configuration
Press the adjusting dial
Select name, plant, hall, cell, additional info by turning the adjusting dial
Press the dial to edit the selection
The keyboard is displayed.
Enter the configuration data by turning and pressing the adjusting dial
Select "OK" (turn adjusting dial and press)
After entering all configuration data, select "Save" (adjusting dial wheel and press)
Reset to factory
settings
Defaults / System / Reset to factory settings
Press the adjusting dial
A confirmation prompt asking whether you really want to restore the factory settings is dis-
played.
Select yes by turning the adjusting dial
Press the adjusting dial to reset to factory settings
The power source is reset to the factory settings.
Reset website
password
Defaults / System / Reset website password
Press the adjusting dial
A confirmation prompt asking whether you really want to reset the website password is dis-
played.
Select yes by turning the adjusting dial
Press the adjusting dial to reset the website password
The website password is reset to the factory setting:
User name = admin
Password = admin
Performing R/L
alignment
NOTE!
R/L alignment must be carried out separately for each welding process.
Welding circuit resistance R [mOhm]
Measuring the welding circuit resistance "r" provides information on the overall resistance
of the torch hosepack, welding torch, workpiece and grounding cable.
1
2
3
4
5
6
7
1
2
3
4
1
2
3
4
To Next Page
Loading...
Need help?
General
