68
MMA welding Press the Mode button
The welding process and operating mode are displayed.
Select electrode welding processes (Stick / MMA) or CEL (turn and press the adjusting
dial)
Turn the adjusting dial to select the Polarity parameter:
DC- / DC+ / AC ... during MMA welding
DC- / DC+ ... during MMA welding with cellulose electrodes
Press the adjusting dial
Set the polarity for the rod electrode to be used by turning the adjusting dial
Confirm the selection by pressing the adjusting dial
Turn the adjusting dial to select further welding parameters
Press the adjusting dial
The value of the parameter is highlighted in blue and can now be changed.
Turn the adjusting dial to: change the value of the parameter
Press the adjusting dial
If required, set further parameters in the Setup menu
(For details, see the "Setup parameters" chapter, starting on page 79)
NOTE!
All welding parameter set values that have been set using the adjusting dial remain
stored until the next time they are changed.
This applies even if the power source is switched off and on again.
Start welding
1
2
3
4
5
6
7
8
9
10
11
12
To Next Page
Loading...
Need help?
General
