Fault Codes
313
027-796 E-mail without an attachment was discarded because the machine is set to print
only the attached document of e-mail. To print body text and the header of e-
mail in addition to its attachments, change settings from [Properties] on
CentreWare Internet Services.
027-797 The output destination is not correct. Specify the correct destination and resend
the e-mail.
034-211
034-212
An error occurred in the fax controller. Contact our Customer Support Center.
034-501 Is the telephone cable correctly connected? Check that the telephone cable is
connected correctly, and resend the document. Refer to Machine Components
in the Product Overview chapter on page 27.
034-507
036-786
036-787
Communication failed because the ID of the remote machine and the password
you specified did not match. Make sure that the password and telephone
number are correct. Also check with the other party that their machine has been
set up to reject ID from other parties. This code is also displayed when a polling
request is rejected.
034-511
035-725
A document for relay broadcasting cannot be transmitted. Check if the relay
station is correctly registered in the specified speed dial code. Also, check the
contents of the address number registered at the relay station.
034-530 No correct operations were performed in a certain period of time. Perform an
operation within a certain period of time.
034-728
034-784
034-785
034-796
035-701
Transmission cannot be made because the telephone number is not correct.
Check the telephone number of the remote machine and send the document
again. Customers who use G3 DP (Dial Pause) should check that the dialed
number does not contain “*” or “#”.
034-790
034-791
034-792
034-793
034-794
034-795
Is the telephone line correctly connected to the machine? Check that the phone
line is connected correctly and send the document again. These codes are
displayed only in certain countries.
035-702
036-507
The other party cancelled the transmission. Ask the other party to check their
machine status and resend the document if necessary.
035-704
035-744
035-745
The specified feature (such as F Code) is not supported by the remote machine.
Contact the other party, and resend the document without using the feature if
required.
035-705
035-708
035-709
035-710
035-712
The remote machine may have encountered a problem. Contact the other party
and resend the document if necessary.
Code Description and Remedy
To Next Page
Loading...
Need help?
General
