18 Appendix
338
Eject Command 152
(SP)
153
(SPO)
154
(NR)
155
(FR)
156
(PG)
157
(AF)
158
(AH)
0 (Default): Off
1: On
Sets the command that indicates a drawing is finished. When
the command specified here is received, drawing is terminated
and the paper is ejected.
[Off]...Does not process as an eject command.
[On]...Processes as an eject command.
On is set as the default for SPO only.
Scaling 159 0: Off
1 (Default): On
Determines the setting to either enlarge or reduce the document
size so that the document size fits the paper size.
[OFF]...Prints in the same size without enlargement/reduction,
even if the document size and paper size are different.
[ON]...Prints while enlarging/reducing the data on document
size so that it fits the paper size.
Scaling Mode 160 0 (Default): Paper size
1: Active coordinate area
Determines how the document size is determined when
Document Size (the item number 101) is set to Auto (99).
[Paper Size]...Make the document size the minimum size that
combines the active coordinate area from the active coordinate
determining method and the active coordinate obtained by the
settings of Origin Position and Paper Margin.
[Active Coordinate Area]...Make the document size the area
from which the paper margin is subtracted from the active
coordinate area obtained by the active coordinate determining
method.
Parameter
Item No.
Value
To Next Page
Loading...
Need help?
General
