Error Code
451
Problem Solving
13
027-446
[Cause] The IP address of IPv6 set manually already exists.
[Remedy] Change the [Manually Configured IPv6 Address] on the machine,
or the IP address of IPv6 on the network device, to remove the
duplication of addresses.
027-447
[Cause] The IP address of IPv6 already exists.
[Remedy] Change the [Link-local Address] for IPv6 on the machine, or the
IP address of IPv6 on the network device, to remove the
duplication of addresses.
027-452
[Cause] IP address of IPv4 already exists.
[Remedy] Change the IP address of IPv4 set on the machine or the IP
address of IPv4 on the network device.
027-500
[Cause] Unable to connect to the SMTP server.
[Remedy] Specify the SMTP server name correctly or specify the server by
using its IP address.
027-501
[Cause] An POP server error occurred.
[Remedy] Execute the operation again. If the error still is not resolved,
contact our Customer Support Center.
027-502
[Cause] Failed to log into the POP3 server when using the POP3 protocol.
[Remedy] Confirm whether the user name and password used in the POP3
server are correct on CentreWare Internet Services.
027-503
[Cause] An POP server error occurred.
[Remedy] Execute the operation again. If the error still is not resolved,
contact our Customer Support Center.
027-504
[Cause] A SMTP server error occurred.
[Remedy] Execute the operation again. If the error still is not resolved,
contact our Customer Support Center.
027-513
[Cause] The machine failed to transfer data using SMB of the Scan to PC
service because access to the SMB server was not permitted.
[Remedy] For information about settings, consult your system administrator,
or the official website of Microsoft Corporation or Apple Japan,
Inc.
027-514
[Cause] The machine failed to transfer data using SMB of the Scan to PC
service because an error has been occurred between the SMB
server and the DNS server.
[Remedy] Check the following conditions:
z
The SMB server is connected to the DNS server.
z
The SMB server name is registered on the DNS server.
027-515
[Cause] The machine failed to transfer data using SMB of the Scan to PC
service because an error has been occurred.
[Remedy] Take the following measures:
z
Set the DNS server address.
z
Set the target SMB server address using IP address.
Error Code Cause and Remedy
To Next Page
Loading...
