11. RS-485 LAN Connector, 3 Pins (J11): To set up an H201Ti network, the H201Ci-Cs
(and/or H201Ci-1s) are daisy-chained together into an RS-485 Local Area Network
(LAN).
Figure 4-3: Circuit Board of the Hydran 201Ci-C
12. Supervisory Link Connector to Termination Board No. 1, 4 Pins (J15): An isolated
supervisory link cable coming from an H201Ti (through the termination board) is
connected here. The link cable carries serial data (communications) and isolated
link supply (+15 Vdc, from the H201Ci-C).
To Next Page
Loading...
