Chapter 8: System Hardware Overview
5495975-1EN Rev.9 8-16
© 2013-2017 General Electric Company. All rights reserved.
12. Control Detent Lock Activates the configured lock detent positions for lateral alignment
and SID. The Locks activate when you position the tube in these
positions.
The green indication light #13 at the up right corner is indicating
the detent lock button is enable and the detent lock is on.
13. Indicator Detent Lock
Indicator
To indicate the detent lock is active. The green light is lit up when
the lock is active.
14. Control Collimator
Field Light
Toggles the collimator field light ON or OFF. The light ON time is
controlled by the system configuration.
15. Sensor Infrared
Sensor
This sensor is at the position where the black circle is indiacting. It
is use to active the all lock release.
Note: If the hand is out of the sensor range, the lock would not
work.
Note: Strongly recommend operate all lock release sensor
without dark color glove, or the lock would not work.
16. Control All-Lock
Release
Releases the lock to allow vertical, lateral and longitudinal motion
of the OTS. The lock is active when you grasp the bulgy part
(indicating the range of the infrared sensor) of the OTS console bar
which has an all lock release indicator on it.
To grasp here would active the infrared sensor above the bar and
then can release the lock.
Table 8-6 OTS Function
Item Number and
Type
Description Description
To Next Page
Loading...
