Chapter 9 Page no. 1616
JC-DR-A-413.fm
GE Healthcare Senographe DS
Revision 1 Service Information and Procedures Class A 2385072-16-8EN
Job Card D/R A413 - BT Power Supply 400-T1
rotary switch in the Generator cabinet (position I).
6. Switch on the Senographe system electrical power (i.e. Generator, Gantry, and Control Station).
Wait until the Gantry boot is complete, and check that no error has been reported.
7. Reinstall the Generator covers (see Job Card PHY A042 - Remove/Reinstall Generator Covers on
page 513).
7 COMPLETION
None.
To Next Page
Loading...
