GE Healthcare Senographe DS
Revision 1 Service Information and Procedures Class A 2385072-16-8EN
Job Card DIAG A003 - AWS File System and SCSI Board Diagnostics
Page no. 989 Chapter 9
JC-DIAG-A-003.fm
Job Card DIAG A003 - AWS File System and SCSI Board Diag-
nostics Chapter 9
1 INTRODUCTION
This Job Card describes diagnostic procedures for the AWS (Acquisition Workstation) File system and
SCSI board.
The AWS consists of a Solaris computer, some components connected externally (e.g., modem) and a
set of subsystems. AWS diagnostics include diagnostics for the workstation hardware, software pro-
cesses in the workstation, and connection to the subsystems.
The diagnostics tests the AWS hardware components, locates any non-functional subsystem, and then
locates a non-functional FRU (Field Replaceable Unit).
1-1 Access to the Tests
There are two ways to launch an AWS diagnostic:
• From a command window as sdc or root user (local use only)
• From the ok prompt (local use only)
2 COMMON PROCEDURES
2-1 Open a Command Window
Right click the screen background; select Service tools and then select Command window from root
menu.
2-2 Go to ok Prompt
Note:
Going to the ok prompt is only applicable to V1/V2 Control Stations.
1. From behind the Browser, launch a command window (see Launching a Command Line Window on
page 120).
A command window appears with an ADS prompt.
2. Log in as root as follows:
a. At the ADS prompt enter:
su
b. When requested to specify the root password, enter:
operator
3. Execute the halt command by entering:
halt
An ok prompt appears.
To Next Page
Loading...
Need help?
General
