GE Healthcare Senographe DS
Revision 1 Service Information and Procedures Class A 2385072-16-8EN
Calibration guides
Page no. 1647 Chapter 9
Calibration.fm
CALIBRATION GUIDES CHAPTER 9
Calibration information is given in the following modules:
- Job Card CAL A001 - Heater Current Scale Factor on page 1649
- Job Card CAL A003 - X-Ray Tube Focal Bias Voltage Scale Factor on page 1655
- Job Card CAL A007 - Automatic X-ray Tube Warm-Up on page 1661
- Job Card CAL A009 - X-Ray Tube mA Measurement on page 1663
- Job Card CAL A011 - Calibration of kV Scale Factor on page 1667
- Job Card CAL A012 - X-Ray Tube Heater Current on page 1673
- Job Card CAL A021 - Arm Rotation Calibration on page 1679
- Job Card CAL A027 - Tube Tilt Calibration on page 1681
- Job Card CAL A029 - Collimator Format Calibration on page 1683
- Job Card CAL A031 - Lift Calibration on page 1687
- Job Card CAL A041 - Bad Pixel Calibration on page 1693
- Job Card CAL A043 - Detector Gain Calibration on page 1697
- Job Card CAL A045 - Conversion Factor Measurement on page 1701
- Job Card CAL A046 - Half-Value Layer Measurement on page 1703
- Job Card CAL A048 - Calibration of Compression Force Sensor on page 1709
- Job Card CAL A049 - Compression Paddle Offset Calibration on page 1711
- Job Card CAL A050 - Compression Thickness Calibration on page 1721
- Job Card CAL A051 - AOP Calibration on page 1723
- Job Card CAL A053 - mAs Non-linearity Calibration on page 1725
To Next Page
Loading...
Need help?
General
