GE Senographe DS User Manual

Chapter 7 Page no. 630
JC-ELE-A-021.fm
GE Healthcare Senographe DS
Revision 1 Service Information and Procedures Class A 2385072-16-8EN
Job Card ELE A021 - Networking Connection and Configuration
7. A Netmask screen appears with a default netmask of 255.255.255.0..
Specify an appropriate netmask as follows:
• lf the Hospital Network Administrator has given you a different netmask to the default value of
255.255.255.0, erase the displayed default Netmask by back-spacing over it. Then type in the
new Netmask address.
• If the Hospital Network Administrator has not given you a different netmask to the default value of
255.255.255.0, leave the default Netmask of 255.255.255.0 as is.
Press the <F2> key to continue.
8. At the IPV6 screen, ensure that No is selected for the Use IPV6 option, and press the <F2> key to
continue.
9. At the Confirmation information screen, ensure that the correct information appears for the eri0 net-
work interface, and press the <F2> key to continue.
A screen indicating a delay may appear while the settings for the eri0 network interface are being
stored.
10. At the Kerberos Security screen, ensure that No is selected for the Use Kerberos Security option,
- Netmask - - - - - - - - - - - - - - - - - - - - - - - - - - -
On this screen .................................
Netmask :
255.255.255.0
‐
IPV6
 
On this screen




………………………………….

Use IPV6

Yes

No

X
‐‐‐‐‐ ‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐
- Confirm information - - - - - - - - - - - - - - - - - - - - - -
> Confirm the following ...........................
.................................................
Host name : XXXXX
Networked : Yes
Primary Network Interface : eri0
IP address : X.X.X.X
Just a moment

GE Senographe DS Specifications

General

Brand	GE
Model	Senographe DS
Category	Medical Equipment
Language	English