GE Senographe DS

Chapter 7 Page no. 646
JC-ELE-A-021.fm
GE Healthcare Senographe DS
Revision 1 Service Information and Procedures Class A 2385072-16-8EN
Job Card ELE A021 - Networking Connection and Configuration
for e1000g0 option, and press the <F2> key to continue.
10. At the Confirmation Information for e1000g0 screen, ensure that the correct information appears for
the e1000g0 network interface, and press the <F2> key to continue.
A screen indicating a delay may appear while the settings for the e1000g0 network interface are
being stored.
11. At the Configure Security Policy screen, ensure that No is selected for the Configure Kerberos Secu-


Default Route for e1000g0

Detect one upon reboot

Specify one


To specify the default route, you can let the software ...



.........................
Set the Default Route for e1000g0
-------------------------
None

X
X



Networked:

> Confirm the following information. If it is correct ...



.........................
Confirm information for e1000g0
Yes
Use DHCP:
No
Host name:
XXXXXX
IP address: N.N.N.N
System part of a subnet:
Yes
Netmask:
N.N.N.N
Enable IPv6:
No
Default Route:
None
Just a moment