314 Programming: Q Parameters
9.8 Additional Functions
The following functions allow you to include the following additional
information in the protocol log file:
Keyword Function
CALL_PATH Gives the path for the NC program where you
will find the FN16 function. Example:
“Measuring program: %S”,CALL_PATH;
M_CLOSE Closes the file to which you are writing with
FN16. Example: M_CLOSE;
ALL_DISPLAY Outputs Q parameter values regardless of
MM/INCH setting of the MOD function
MM_DISPLAY Outputs Q parameter values in millimeters, if
MM display is set in the MOD function
INCH_DISPLAY Converts Q parameter values to inches if INCH
display is set in the MOD function
L_ENGLISH Display text only in English conversational
L_GERMAN Display text only in German conversational
L_CZECH Display text only in Czech conversational
L_FRENCH Display text only in French conversational
L_ITALIAN Display text only in Italian conversational
L_SPANISH Display text only in Spanish conversational
L_SWEDISH Display text only in Swedish conversational
L_DANISH Display text only in Danish conversational
L_FINNISH Display text only in Finnish conversational
L_DUTCH Display text only in Dutch conversational
L_POLISH Display text only in Polish conversational
L_PORTUGUE Display text only in Portuguese conversational
L_HUNGARIA Display text only in Hungarian conversational
L_RUSSIAN Display text only in Russian conversational
L_SLOVENIAN Display text only in Slovenian conversational
L_ALL Display text independently of the
conversational language
HOUR Number of hours from the real-time clock
MIN Number of minutes from the real-time clock
SEC Number of seconds from the real-time clock
To Next Page
Loading...
