HEIDENHAIN iTNC 530 449
12.2 The PLANE Function: Tilting the Working Plane (Software Option 1)
12.2 The PLANE Function: Tilting
the Working Plane (Software
Option 1)
Introduction
The PLANE function is a powerful function for defining tilted working
planes in various manners.
All PLANE functions available on the TNC describe the desired working
plane independently of the rotary axes actually present on your
machine. The following possibilities are available:
The machine manufacturer must enable the functions for
tilting the working plane!
You can only use the PLANE function on machines which
have at least two rotary axes (head and/or table).
Exception: PLANE AXIAL can also be used if only a single
rotary axis is present or active on your machine.
Function Required parameters Soft key Page
SPATIAL Three space angles: SPA,
SPB, and SPC
Page 453
PROJECTED Two projection angles:
PROPR and PROMIN and a
rotation angle ROT
Page 455
EULER Three Euler angles:
precession (EULPR),
nutation (EULNU) and
rotation (EULROT)
Page 457
VECTOR Norm vector for defining
the plane and base vector
for defining the direction of
the tilted X axis
Page 459
POINTS Coordinates of any three
points in the plane to be
tilted
Page 461
RELATIVE Single, incrementally
effective spatial angle
Page 463
AXIAL Up to three absolute or
incremental axis angles
A, B, C
Page 464
RESET Reset the PLANE function Page 452
To Next Page
Loading...
Need help?
General
