684 Tables and Overviews
18.3 Technical Information
Global Program Settings software option
Function for superimposing
coordinate transformations in
the Program Run modes
îš„ Swapping axes
îš„ Superimposed datum shift
îš„ Superimposed mirroring
îš„ Axis locking
îš„ Handwheel superimposition
îš„ Superimposed basic rotation and datum-based rotation
îš„ Feed rate factor
Adaptive Feed Control software option (AFC)
Function for adaptive feed-
rate control for optimizing the
machining conditions during
series production
îš„ Recording the actual spindle power by means of a teach-in cut
îš„ Defining the limits of automatic feed rate control
îš„ Fully automatic feed control during program run
KinematicsOpt software option
Touch-probe cycles for
automatic testing and
optimization of the machine
kinematics
îš„ Backup/restore active kinematics
îš„ Test active kinematics
îš„ Optimize active kinematics
3D-ToolComp software option
3-D tool radius compensation
depending on the tool’s
contact angle
îš„ Compensate the delta radius of the tool depending on the tool's contact angle at the
workpiece
îš„ Prerequisite: LN blocks
îš„ Compensation values can be defined in a separate table
FCL 2 upgrade functions
Enabling of significant
improvements
îš„ Virtual tool axis
îš„ Touch probe cycle 441, Rapid Probing
îš„ Offline CAD point filter
îš„ 3-D line graphics
îš„ Contour pocket: Assign a separate depth to each subcontour
îš„ smarT.NC: Coordinate transformation
îš„ smarT.NC: PLANE function
îš„ smarT.NC: Graphically supported block scan
îš„ Expanded USB functionality
îš„ Network attachment via DHCP and DNS
To Next Page
Loading...
Need help?
General
