New functions in version 60642x-01 since the predecessor version 34049x-05
14
Several special functions (SPEC FCT) are now available in the MDI
operating mode (see "Programming and executing simple machining
operations" on page 624)
There is a new manual probing cycle that can be used to
compensate workpiece misalignments by rotating the rotary table
(see "Workpiece alignment using 2 points" on page 607)
New touch probe cycle for calibrating a touch probe by means of a
calibration sphere (see User's Manual for Cycle Programming)
KinematicsOpt: Better support for positioning of Hirth-coupled axes
(see User's Manual for Cycle Programming)
KinematicsOpt: An additional parameter for determination of the
backlash in a rotary axis was introduced (see User's Manual for
Cycle Programming)
New Cycle 275 for Trochoidal Slot Milling (see User’s Manual for
Cycle Programming)
In Cycle 241 "Single-Fluted Deep-Hole Drilling" it is now possible to
define a dwell depth (see User's Manual for Cycle Programming)
The approach and departure behavior of Cycle 39 "Cylinder Surface
Contour" can now be adjusted (see User's Manual for Cycle
Programming)
To Next Page
Loading...
