HEIDENHAIN ITNC 530 - HELP Key

Changed functions in version 60642x-04
HEIDENHAIN iTNC 530 25
Changed functions in version
60642x-04
 DXF converter:
 The direction of a contour is now already defined by the first click
on the first contour element (see "Selecting and saving a contour"
on page 280)
 Multiple drilling positions that have already been selected can
now be deleted by drawing a rectangle around them while
pressing the CTRL key (see "Quick selection of hole positions in
an area defined by the mouse" on page 285)
 The TNC shows the drives in the file manager in a defined sequence
(see "Calling the file manager" on page 127)
 The TNC evaluates the column PITCH of the tool table in connection
with tapping cycles (see "Tool table: Standard tool data" on page 182)