HEIDENHAIN ITNC 530 - Reset TCPM FUNCTION

518 Programming: Execution of CAM Programs, Multi-axis Machining
12.5 TCPM FUNCTION (software option 2)
Reset TCPM FUNCTION
 FUNCTION RESET TCPM is to be used if you want to
purposely reset the function within a program
Example NC block:
...
25 FUNCTION RESET TCPM Reset TCPM FUNCTION
...
The TNC automatically resets FUNCTION TCPM if you select
a new program in a program run mode.
You can reset the TCPM FUNCTION only if the PLANE function
is inactive. If required, run PLANE RESET before FUNCTION
RESET TCPM