HEIDENHAIN ITNC 530 - 16.4 Program Run; Application

HEIDENHAIN iTNC 530 647
16.4 Program Run
16.4 Program Run
Application
In the Program Run, Full Sequence mode of operation the TNC
executes a part program continuously to its end or up to a program
stop.
In the Program Run, Single Block mode of operation you must start
each block separately by pressing the machine START button.
The following TNC functions can be used in the program run modes of
operation:
 Interrupting the program run
 Starting the program run from a certain block
 Optional block skip
 Editing the tool table TOOL.T
 Checking and changing Q parameters
 Superimposing handwheel positioning
 Functions for graphic simulation
 Additional status display