HEIDENHAIN ITNC 530 - 16.6 Optional block skip; Application; Erasing the; character

HEIDENHAIN iTNC 530 659
16.6 Optional block skip
16.6 Optional block skip
Application
In a test run or program run, the control can skip over blocks that begin
with a slash "/":
 To run or test the program without the blocks
preceded by a slash, set the soft key to ON
 To run or test the program with the blocks preceded
by a slash, set the soft key to OFF
Erasing the "/" character
 In the Programming and Editing mode you select the block in which
the character is to be erased
 Erasing the "/" character
This function does not work for TOOL DEF blocks.
After a power interruption the control returns to the most
recently selected setting.