HEIDENHAIN ITNC 530 - 2 Introduction..... 77

30
2.1 The iTNC 530 ..... 78
Programming: HEIDENHAIN conversational, smarT.NC and ISO formats ..... 78
Compatibility ..... 78
2.2 Visual display unit and keyboard ..... 79
Visual display unit ..... 79
Set the screen layout ..... 80
Operating panel ..... 81
2.3 Operating modes ..... 82
Manual Operation and El. Handwheel ..... 82
Positioning with Manual Data Input ..... 82
Programming and Editing ..... 83
Test Run ..... 83
Program Run, Full Sequence and Program Run, Single Block ..... 84
2.4 Status displays ..... 85
"General" status display ..... 85
Additional status displays ..... 87
2.5 Window manager ..... 95
Task bar ..... 96
2.6 SELinux security software ..... 97
2.7 Accessories: HEIDENHAIN touch probes and electronic handwheels ..... 98
Touch probes ..... 98
HR electronic handwheels ..... 99
2 Introduction ..... 77