48
14.1 Switch-on, switch-off ..... 564
Switch-on ..... 564
Switch-off ..... 566
14.2 Moving the machine axes ..... 567
Note ..... 567
Moving the axis using the machine axis direction buttons ..... 567
Incremental jog positioning ..... 568
Traversing with electronic handwheels ..... 569
14.3 Spindle speed S, feed rate F and miscellaneous functions M ..... 579
Application ..... 579
Entering values ..... 579
Changing the spindle speed and feed rate ..... 580
14.4 Functional safety FS (option) ..... 581
Miscellaneous ..... 581
Explanation of terms ..... 582
Checking the axis positions ..... 583
Overview of permitted feed rates and speeds ..... 584
Activating feed-rate limitation ..... 585
Additional status displays ..... 585
14.5 Workpiece presetting without a touch probe ..... 586
Note ..... 586
Preparation ..... 586
Workpiece presetting with axis keys ..... 587
Management of presets with the preset table ..... 588
14.6 Using touch-probes ..... 595
Overview ..... 595
Selecting touch probe cycles ..... 596
Recording measured values from the touch-probe cycles ..... 596
Writing the measured values from touch probe cycles to datum tables ..... 597
Writing the measured values from touch probe cycles in the preset table ..... 598
Storing measured values in the pallet preset table ..... 598
14.7 Calibrating touch probes ..... 599
Introduction ..... 599
Calibrating the effective length ..... 599
Calibrating the effective radius and compensating center offset ..... 600
Displaying calibration values ..... 601
Managing more than one block of calibration data ..... 601
14.8 Compensating workpiece misalignment with a 3-D touch probe ..... 602
Introduction ..... 602
Basic rotation using 2 points: ..... 604
Determining basic rotation using 2 holes/studs: ..... 606
Workpiece alignment using 2 points ..... 607
14 Manual Operation and Setup ..... 563
To Next Page
Loading...
