HEIDENHAIN iTNC 530 487
12.1 Execution of CAM programs
Possibilities for user intervention on the TNC
Cycle 32 TOLERANCE is available for the influencing of CAM programs
directly on the TNC. Pay attention to the description of functions for
Cycle 32 in the “Cycles: Special Functions” chapter of the Cycle
Programming User's Manual. Also note the interactions with the
chord error defined in the CAM system, see "Please note the following
for CAM programming", page 485.
Beispiel: NC blocks for Cycle 32
95 CYCL DEF 32.0 TOLERANCE
96 CYCL DEF 32.1 T0.05
97 CYCL DEF 32.2 HSC-MODE:1 TA3
Some machine tool builders provide an additional cycle for
adapting the behavior of the machine to the respective
machining operation, such as Cycle 332 Tuning. Cycle
332 can be used to modify filter settings, acceleration
settings, and jerk settings. Your machine manual provides
more detailed information.
To Next Page
Loading...
