204 Programming: Tools
5.2 Tool data
There are two ways to run a tool usage test for a pallet file:
The highlight is on a pallet entry in the pallet file:
The TNC runs the tool usage test for the entire pallet
The highlight is on a program entry in the pallet file:
The TNC runs the tool usage test only for the selected program
BLOCK Block number in which the TOOL CALL block
was programmed
PATH TOKEN = TOOL: Path name of the active main
program or subprogram
TOKEN = STOTAL: Path name of the
subprogram
T Tool number with tool index
OVRMAX Maximum feed rate override that occurred
during machining. During Test Run the TNC
enters the value 100 (%)
OVRMIN Minimum feed rate override that occurred
during machining. During Test Run the TNC
enters the value –1
NAMEPROG 0: The tool number is programmed
1: The tool name is programmed
Column Meaning
To Next Page
Loading...
