HEIDENHAIN ITNC 530 - Reloading the NC Software Used; Preparations

HEIDENHAIN iTNC 530 209
5.2 Tool data
If the form view is active, the following functions are available to you:
Editing functions, form view Soft key
Select the tool data of the previous tool
Select the tool data of the next tool
Select previous tool index (only active if indexing
is enabled)
Select the next tool index (only active if indexing
is enabled)
Discard all changes made since the form was
called ("Undo" function)
Insert new tool (2nd soft-key row)
Delete tool (2nd soft-key row)
Insert tool index (2nd soft-key row)
Delete tool index (2nd soft-key row)
Copy the tool data of the selected tool (2nd soft-
key row)
Insert the copied tool data in the selected tool
(2nd soft-key row)
Select/deselect check boxes (e.g. for TL line)
Open selection lists of combo boxes (e.g. for AFC
line)