New functions in version 60642x-04
HEIDENHAIN iTNC 530 21
Cycle 225: Input of German umlauts is now possible; text can also
be arranged at an angle (see User’s Manual for Cycle Programming)
Cycle 253: Input parameter Q439 for feed rate reference added (see
User’s Manual for Cycle Programming)
Cycle 254: Input parameter Q439 for feed rate reference added (see
User’s Manual for Cycle Programming)
Cycle 276: Automatic identification of residual material added (see
User’s Manual for Cycle Programming)
Cycle 290: It is now also possible to machine a recess with Cycle
290 (see User’s Manual for Cycle Programming)
Cycle 404: Input parameter Q305 added to allow saving a basic
rotation in any line of the datum table (see User’s Manual for Cycle
Programming)
Cycle 253: With Cycle 253, Slot Milling, a parameter is now available
with which you can define the feed rate reference when machining
the slot (see User's Manual for Cycle Programming)
Cycle 254: With Cycle 254, Circular Slot, a parameter is now
available with which you can define the feed rate reference when
machining the slot (see User's Manual for Cycle Programming)
To Next Page
Loading...
