344 Programming: Q Parameters
9.8 Additional functions
Values from global program
settings GS, 332
1 0 Value of basic rotation
2 1 to 9 (X to W) Provides the index of the axis on which the
queried axis was swapped: 1=X, 2=Y, 3=Z, 4=Y,
5=B, 6=C, 7=U, 8=V, 9=W
3 1 to 9 (X to W) Provides 1 if the queried axis is mirrored
4 1 to 9 (X to W) Supplies the shift value of the queried axis
5 0 Provides the active rotation angle
6 0 Provides the active value of the feed-rate override
7 1 to 9 (X to W) Provides 1 if the queried axis is disabled
8 1 to 10 (X to VT) Provides the max. value of the handwheel
superimposition in the queried axis
9 1 to 10 (X to VT) Provides the actual value of the handwheel
superimposition in the queried axis
11 1 to 7 Provides the values X Min, X Max, Y Min, Y Max, Z
Min, Z Max, Safety clearance
12 1 to 7 Returns the value 0 if the respective value is set to
inactive, otherwise 1. Index identical to FN18
ID332 NR11
13 0 Returns the selected coordinate system
0=Machine coordinate system,
1=Workpiece coordinate system,
2=Input coordinate system
14 0 "Machining at limit height" mode: 0=No
machining, 1=Machine at limit
TS triggering touch probe, 350 10 - Touch probe axis
11 - Effective ball radius
12 - Effective length
13 - Radius setting ring
14 1 Center offset (reference axis)
2 Center offset (minor axis)
15 - Direction of center misalignment compared with
0° position. The value refers to 4096 increments
per 360°. The value 1 therefore equals
0.087890625°
Group name, ID no. Number Index Meaning
To Next Page
Loading...
