HEIDENHAIN iTNC 530 449
11.6 Adaptive Feed Control (AFC—software option)
Proceed as follows to select the <name>.H.AFC2.DEP file:
Select the Program Run, Full Sequence operating
mode
Shift the soft-key row
Select the table of AFC settings
Show the log file
The TNC records the total machining time for all teach-in
cuts (LTIME), all control cuts (CTIME) and the total time
difference (TDIFF), and enters this data after the keyword
TOTAL in the last line of the log file.
The TNC can only calculate the time difference (TDIFF) if
you have completed the teach-in step. Otherwise the
column remains empty.
To Next Page
Loading...
