720 Tables and Overviews
18.1 General user parameters
Error message during cycle call MP7441
Display error message if M3/M4 not active: Bit 0 = 0
Suppress error message if M3/M4 not active: Bit 0 = 1
Reserved: Bit 1
Suppress error message if positive depth programmed: Bit 2 = 0
Display error message if positive depth programmed: Bit 2 = 1
M function for spindle orientation in the
fixed cycles
MP7442
Function inactive: 0
Orientation directly through the NC: -1
M function for orienting the spindle: 1 to 999
Maximum contouring speed at feed rate
override setting of 100% in the Program Run
modes
MP7470
0 to 99 999 [mm/min]
Feed rate for rotary-axis compensation
movements
MP7471
0 to 99 999 [mm/min]
Compatibility machine parameters for
datum tables
MP7475
Datum shifts are referenced to the workpiece datum: 0
If the value 1 was entered in older TNC controls or in controls with
software 340420-xx, datum shifts were referenced to the machine datum.
This function is no longer available. You must now use the preset table
instead of datum tables referenced to REF (see "Management of presets
with the preset table" on page 588).
Time to be added when calculating the tool
usage time
MP7485
0 to 100 [%]
Machining and program run
To Next Page
Loading...
