Global Masking Framing Fade Edge
Four Image Edge Fade parameters let you control the Edge Fade for individual sides of your object (top, bottom, left and
right). When projecting abutting images, adjusting the Edge Fade parameter lets you smooth the line between two images
and also allows you to change an object’s boundary.
Default DMX Value:
0 = all edges are sharp and hard.
Adjust each side separately for edge fade from 0 = no fade to 255 (100%) = opaque.
Mask Edge Fade
The Mask Edge Fade parameter operates differently depending on the value of the Mask Select
parameter.
Default DMX Value:
0 = no adjustment to mask
When the Mask Select parameter value = 0 to 127 (49%), Mask Edge Fade adjusts the amount of fading from a DMX
value of 0 = no edge fade to 255 (100%)= maximum edge fade.
When the Mask Select parameter value =128 (50%) to 255 (100%), the strobing masks are selected and Mask Edge
Fade adjusts the speed of the strobing from minimum at a DMX value = 0 to a maximum strobe speed at a DMX value =
255 (100%),
To Next Page
Loading...
