Configuration Options - MMS100
Before programming a MMS100 fixture from a DMX512 console, configure the fixture by:
• Selecting the DMX source for the fixture.
• Selecting the Protocol Version that the fixture will respond to.
• Selecting the number of Graphic Layers, this will determine the DMX channel footprint size.
• Selecting a Fixture ID number to uniquely identify the MMS100 on a fixture link (required if you will be
synchronizing output between fixtures).
• Assigning a valid Start Channel (the first DMX channel designated by the console for this fixture).
• These and other configuration options are accessible directly using the MMS100 menu system or
remotely using the Content Management Application (CMA).
To Next Page
Loading...
