Effect Film Noise
Film Noise
Effect Mode parameter DMX value = 94
This effect creates the effect of scratches on film. You can adjust the amount of “noise” as well as the tint and “jitter” to
give the image an aged film effect.
• Modifier 1: Adjusts the noise rate. A DMX value of 128 (50%) pauses the noise. Values below the midpoint adjust
the rate from 0 = fastest to 127 = slowest. Values above the midpoint adjust the rate from 129 = slowest to 255
(100%) = fastest.
• Modifier 2: Shifts the color to a sepia tint, 128 = no adjustment, 0 to 127 = full sepia. Values above the midpoint of
the range repeat the push to sepia with jitter added from 129 (51%) = full color and no jitter to 255 (100%) = full
sepia and maximum jitter.
• Modifier 3: Reduces the noise level from 0 = maximum noise to 255 (100%) = no noise.
To Next Page
Loading...
