High End Systems MMS100 - Effect Downward Vertical Streaks

Effect Downward Vertical Streaks
Downward Vertical Streaks
Effect Mode parameter DMX value = 80
This effect lets you convert a portion of the image into vertical streaks. You can also rotate the angle of the streak and
fade from the original image to the image with the streak effect applied.
• Modifier 1:At a DMX value of 0, there is no effect. Increasing the DMX value sets the length of the streak portion
of the image from the bottom up to 255 (100%) = the full image converted to streaks.
• Modifier 2:The default DMX value of 128 (50%) = no adjustment. Values below the midpoint move the edge of the
streaked portion of the image clockwise as you approach 0 = 90°. Values above the midpoint move the edge of
the streaked portion of the image counterclockwise as you approach 90° at a value of 255 (100%).
• Modifier 3:When Modifier 1 has a DMX value > 0, Modifier 3 lets you fade from 0 = the original image to 255
(100%) = the converted image.