Effect Film Burn
Film Burn/Unburn
Effect Mode parameter DMX value = 93
This effect creates multiple burn patterns over the image.
• Modifier 1: Adjust the burn-through rate. A DMX value of 65 begins creating a burn pattern with flames from 64 =
slowest to 127 = fasted rate. Values below 65 “unburn the pattern from 63 = slowest to 0 = fastest unburn. Values
in the upper half of the range create the burn pattern without flames from 192 = slowest to 255 = fastest burn
rate. A value of 191 “unburns” the patterns from 191 = slowest to 128 = fastest “unburn” without flames.
• Modifier 2: Adjusts the amount of film blackening around the burn areas from 0 = the smallest amount of
blackening to 255 (100%) = the largest blackened area.
• Modifier 3: Each DMX value selects one of 255 burn patterns.
To Next Page
Loading...
