Powering on the MMS100
To power the MMS100, simply connect the fixture to an appropriately-rated power source.
WARNING:
This equipment is designed for connection to a branch circuit having a maximum overload
protection of 20 A.
CAUTION:
Do not power on the fixture until verifying that the line cord cap is suitable for the power
source in your location. For more information, see Attaching a Power Cord Cap in App
endix.
Be sure no mirror can move freely and will not strike anything.
CAUTION:
Always isolate MMS
100 fixtures from generators with a UPS or good quality power conditioner
to prevent damage. Specific damage can occur due to generator drop
-outs, sharp voltage and
To Next Page
Loading...
