MMS100 Shutdown
The shutdown of the MMS100 server requires no careful consideration, however take note of the shutdown procedure of
the attached projector. Projection lamp life can be greatly shorten if a propper shutdown procedure is not followed.
It is possible to reset various portions of the system menu buttons.
• Press and hold the 2 outer most buttons for at least 5 seconds. This will trigger the internal relay to open,
removing power from the server
• Press and hold the 2 outer most buttons for at least 5 seconds to trigger the relay again, this will apply
power to the server and start the boot sequence.
• To reset the motion system, power cycle the entire fixture.
To Next Page
Loading...
