Figure 8-6 Manual Mode
3.
Enable the
Aendance Status funcon.
Result
When you authencate on the inial page, you will enter the
Select Status page. Select a status to take aendance.
Note
If you do not select a status, the authencaon will be failed and
it will not be marked as a valid aendance.
8.5.2 Set Auto Aendance
Set the aendance mode as auto, and you can set the aendance
status and its available schedule. The system will auto change the
aendance status according to the congured parameters.
Before You Start
Add at least one user, and set the user's authencaon mode. For
details, see User Management.
Steps
1.
Tap T&A Status to enter the T&A Status page.
2.
Set the
Aendance Mode as Auto.
Figure 8-7 Auto Mode
3.
Select an aendance status and set its schedule.
Note
The aendance status will be valid within the congured
schedule. For example, if set the break out's schedule as
Monday 11:00, and break in's schedule as Monday 12:00, the
valid user's authencaon from Monday 11:00 to 12:00 will be
marked as break.
23
To Next Page
Loading...
Need help?
General
