The added rst person(s) will list in the First Person List
6.
Oponal: Select a rst person from the list and click Delete to
remove the person from the rst person list.
7.
Click Save.
9.4.7 Congure An-Passback
You can set to only pass the access control point according to the
specied path and only one person could pass the access control
point
aer swiping the card.
Before You Start
Enable the an-passing back funcon of the access control
device.
Perform this task when you want to
congure the an-passing
back for the access control device.
Steps
Note
Either the an-passing back or mul-door interlocking funcon
can be congured for an access control device at the same me.
For the conguraon of mul-door interlocking, refer to
Congure Mul-door Interlocking.
1.
Click Access Control Advanced Funcon An-Passback to enter
the
An-Passpack Sengs page.
2.
Select an access control device on the
le panel.
3.
Select a card reader as the beginning of the path in the First
Card Reader eld.
4.
Click
of the selected rst card reader in the Card Reader
Aerward column to open the select card reader dialog.
5.
Select the
aerward card readers for the rst card reader.
Note
Up to four aerward card readers can be added as aerward
card readers for one card reader.
6.
Click OK in the dialog to save the
selecons.
7.
Click Save in the An-Passback Sengs page to save the
sengs and take eect.
Example
Set Card Swiping Path
If you select Reader In_01 as the beginning, and select Reader
In_02, Reader Out_04 as the linked card readers. Then you can
only get through the access control point by swiping the card in
the order as Reader In_01, Reader In_02 and Reader Out_04.
9.4.8
Congure Mul-door Interlocking
You can set the mul-door interlocking between mulple doors of
the same access control device. To open one of the doors, other
doors must keep closed. That means in the interlocking combined
door group, up to one door can be opened at the same
me.
Perform this task when you want to realize interlocking between
mulple doors.
63