HIKVISION DS-K1T605 Series User Manual

5.
Enable the event so that when the event is detected, en event
will be sent to the client and the linkage acons will be
triggered.
6.
Oponal: Click Copy to... to copy the event sengs to other
access control device, alarm input, door/elevator, or card
reader.
9.5.2 Congure Device Acons for Access Event
You can set the access control device's linkage acons for the
access control device's triggered event. When the event is
triggered, it can trigger the alarm output, host buzzer, and other
acons on the same device.
Steps
Note
It should be supported by the device.
1.
Click Access Control Linkage
Conguraon .
2.
Select the access control device from the list on the le.
3.
Click Add buon to add a new linkage.
4.
Select the event source as Event Linkage.
5.
select the event type and detailed event to set the linkage.
6.
In the Linkage Target area, set the property target to enable
this
acon.
Buzzer on Controller
The audible warning of access control device will be
triggered.
Capture
The real-me capture will be triggered.
Recording
The recording will be triggered.
Note
The device should support recording.
Buzzer on Reader
The audible warning of card reader will be triggered.
Alarm Output
The alarm output will be triggered for
nocaon.
Alarm Input
Arm or disarm the alarm input.
Note
The device should support alarm input funcon.
Access Point
The door status of open, close, remain open, and remain
close will be triggered.
Note
The target door and the source door cannot be the same
one.
Audio Play
71

HIKVISION DS-K1T605 Series Specifications

General

Brand	HIKVISION
Model	DS-K1T605 Series
Category	IP Access Controllers
Language	English