HIKVISION DS-K1T605 Series User Manual

All the added persons with no card issued will display.
3.
Set the card issuing parameters. For details, refer to Set Card
Issuing Parameters.
4.
Click Inialize to inialize the card enrollment staon or card
reader to make it ready for issuing cards.
5.
Click the card number column and enter the card number.
-
Place the card on the card enrollment
staon.
-
Swipe the card on the card reader.
-
Enter the card number manually and press Enter key on your
keyboard.
The card number will be read automacally and the card will
be issued to the person in the list.
6.
Repeat the above step to issue the cards to the persons in the
list in sequence.
9.1.21 Report Card Loss
If the person lost his/her card, you can report the card loss so
that the card's related access
authorizaon will be inacve.
Steps
1.
Enter Person module.
2.
Select the person you want to report card loss for and click Edit
to open the Edit Person window.
3.
In the Credenal Card panel, click on the added card to set
this card as lost card.
Aer reporng card loss, the access authorizaon of this card
will be invalid and
inacve. Other person who gets this card
cannot access the doors by swiping this lost card.
4.
Oponal: If the lost card is found, you can click to cancel the
loss.
Aer cancelling card loss, the access authorizaon of the
person will be valid and acve.
5.
If the lost card is added in one access group and the access
group is applied to the device already,
aer reporng card loss
or cancelling card loss, a window will pop up to nofy you to
apply the changes to the device.
Aer applying to device, these
changes can take eect on the device.
9.1.22 Set Card Issuing Parameters
The client provides two modes for reading a card's number: via
card enrollment staon or via the card reader of the access
control device. If a card enrollment
staon is available, connect it
to the PC running the client by USB interface or COM, and place
the card on the card enrollment to read the card number. If not,
you can also swipe the card on the card reader of the added
access control device to get the card number. As a result, before
issuing a card to one person, you need to set the card issuing
parameters including the issuing mode and related parameters.
When adding a card to one person, click
Sengs to open the Card
Issuing
Sengs window.
Local Mode: Issue Card by Card Enrollment
Staon
Connect a card enrollment staon to the PC running the client.
You can place the card on the card enrollment staon to get the
card number.
45

HIKVISION DS-K1T605 Series Specifications

General

Brand	HIKVISION
Model	DS-K1T605 Series
Category	IP Access Controllers
Language	English