HIKVISION DS-K1T605 Series User Manual

Note
•
For each access control point (door), up to four
authencaon groups can be added.
•
For the authencaon group of which authencaon type is
Local Authencaon, up to 8 person/card groups can be
added to the
authencaon group.
•
For the authencaon group of which authencaon type is
Local Authencaon and Super Password or Local
Authencaon and Remotely Open Door, up to 7 person/
card groups can be added to the authencaon group.
7.
Click Save.
9.4.4 Congure Custom Wiegand Rule
Based on the knowledge of uploading rule for the third party
Wiegand, you can set
mulple customized Wiegand rules to
communicate between the device and the third party card
readers.
Before You Start
Wire the third party card readers to the device.
Perform this task to
congure the custom Wiegand rule for the
third party card readers.
Steps
Note
•
By default, the device disables the custom wiegand funcon. If
the device enables the custom Wiegand funcon, all wiegand
interfaces in the device will use the customized wiegand
protocol.
•
Up to 5 custom Wiegands can be set.
•
For details about the custom Wiegand, see .
1.
Click Access Control Advanced
Funcon Custom Wiegand to
enter the Custom Wiegand page.
2.
Select a custom Wiegand on the
le.
3.
Create a Wiegand name.
Note
Up to 32 characters are allowed in the custom Wiegand name.
4.
Click Select Device to select the access control device for
seng the custom wiegand.
5.
Set the parity mode according to the property of the third
party card reader.
Note
•
Up to 80 bits are allowed in the total length.
•
The odd parity start bit, the odd parity length, the even
parity start bit and the even parity length range from 1 to 80
bit.
•
The start bit of the card ID, the manufacturer code, the site
code, and the OEM should range from 1 to 80 bit.
6.
Set output
transformaon rule.
60

HIKVISION DS-K1T605 Series Specifications

General

Brand	HIKVISION
Model	DS-K1T605 Series
Category	IP Access Controllers
Language	English