HIKVISION DS-K1T605 Series - Customize Person Information; Configure Resident Information

If the person is a visitor, set the maximum mes of
authencaons, including access by card and ngerprint to
limit the visitor's access mes.
Note
The maximum mes of authencaons should be between 1
and 100.
Device Operator
For person with device operator role, he/she is authorized to
operate on the access control devices.
Note
The Super User, Extended Door Open Time, Add to Blacklist,
and Mark as Visitor funcons cannot be enabled concurrently.
For example, if one person is set as super user, you cannot
enable extended door open me for her/him, add her/him to
the blacklist, or set her/him as visitor.
4.
Conrm to add the person.
-
Click Add to add the person and close the Add Person
window.
-
Click Add and New to add the person and
connue to add
other persons.
9.1.10 Customize Person
Informaon
You can customize the person properes which are not pre-
dened in the client according to actual needs, e.g., place of
birth. Aer customizing, when add a person, you can enter the
custom
informaon to make the person informaon complete.
Steps
1.
Enter Person module.
2.
Set the
elds of custom informaon.
1) Click Custom Property.
2) Click Add to add a new property.
3) Enter the property name.
4) Click OK.
3.
Set the custom informaon when adding a person.
1) Select an organizaon in the organizaon list to add the
person and click Add.
Note
Enter the person's basic informaon rst. For details about
conguring person's basic informaon, refer to Congure
Basic Informaon.
2) In the Custom Informaon panel, enter the person
informaon.
3) Click Add to add the person and close the Add Person
window, or click Add and New to add the person and
connue to add other persons.
9.1.11
Congure Resident Informaon
If the person is resident, for video intercom purpose, you need to
set the room number for her/him and bind an indoor
staon.
40