HIKVISION DS-K1T605 Series User Manual

3) View the apply status in the Status column or click Applying
Statusto view all the applied access group(s).
The selected persons in the applied access groups will have the
authorizaon to enter/exit the selected doors/door staons
with their linked card(s) or ngerprints.
9.
Oponal: Click to edit the access group if necessary.
9.4 Congure Advanced Funcons
You can congure the advanced funcons of access control to
meet some special requirements in dierent scene, such as mul-
factor authencaon, an-passback, etc.
Note
•
For the card related funcons(the type of access control card/
mul-factor authencaon), only the card(s) with access group
applied will be listed when adding cards.
•
The advanced funcons should be supported by the device.
•
Hover the cursor on the Advanced
Funcon, and then Click
to customize the advanced funcon(s) to be displayed.
9.4.1 Congure Device Parameters
Aer adding the access control device, you can congure the
parameters of access control device (access controller), access
control points (door or
oor), alarm inputs, alarm outputs, card
readers and lane controller.
Congure Parameters for Access Control Device
Aer adding the access control device, you can congure its
parameters, including overlaying user
informaon on picture,
uploading pictures aer capturing, saving captured pictures, etc.
Steps
1.
Click Access Control Advanced
Funcon Device Parameter .
Note
If you can nd Device Parameter in the Advanced Funcon list,
Hover the cursor on the Advanced Funcon, and then Click
to select the Device Parameter to be displayed.
2.
Select an access device to show its parameters on the right
page.
3.
Turn the switch to ON to enable the corresponding
funcons.
Note
•
The displayed parameters may vary for dierent access
control devices.
•
Some of the following parameters are not listed in the Basic
Informaon page, click More to edit the parameters.
RS-485 Comm. Redundancy
You should enable this funcon if you wire the RS-485 card
reader to the access control device redundantly.
Display Detected Face
Display face picture when
authencang.
Display Card Number
50

HIKVISION DS-K1T605 Series Specifications

General

Brand	HIKVISION
Model	DS-K1T605 Series
Category	IP Access Controllers
Language	English