HIKVISION DS-K1T605 Series - Configure First Person in

4.
Click the icon to select a card reader authencaon mode, and
drag the cursor to draw a color bar on the schedule, which
means in that period of me, the card reader authencaon is
valid.
5.
Repeat the above step to set other
me periods.
6.
Oponal: Select a congured day and click Copy to Week to
copy the same sengs to the whole week.
7.
Oponal: Click Copy to to copy the sengs to other card
readers.
8.
Click Save.
9.4.6 Congure First Person In
You can set mulple rst persons for one access control point.
Aer the rst person is authorized, it allows mulple persons
access the door or other authencaon acons.
Before You Start
Set the access group and apply the access group to the access
control device. For details, refer to Set Access Group to Assign
Access
Authorizaon to Persons.
Perform this task when you want to congure opening door with
rst person.
Steps
1.
Click Access Control Advanced
Funcon First Person In to enter
the First Person In page.
2.
Select an access control device in the list on the le panel.
3.
Select the current mode as Enable Remaining Open
aer First
Person, Disable Remaining Open aer First Person, or
Authorizaon by First Person from the drop-down list for each
access control point of the selected device.
Enable Remaining Open
aer First Person
The door remains open for the congured me duraon
aer the rst person is authorized unl the remain open
duraon ends. If you select this mode, you should set the
remain open duraon.
Note
The remain open duraon should be between 0 and 1440
minutes. By default, the remain open duraon is 10 minutes.
Disable Remaining Open aer First Person
Disable the funcon of rst person in, namely normal
authencaon.
Authorizaon by First Person
All authencaons (except for the authencaons of super
card, super password, duress card, and duress code) are
allowed only
aer the rst person authorizaon.
Note
You can authencate by the rst person again to disable the
rst person mode.
4.
Click Add on the First Person List panel.
5.
Select person(s) in the
le list and the person(s) will be add to
the selected persons as the rst person(s) of the doors.
62